For Residential and Pressure Sewer Applications

The MG200 Series Are 2 HP submersible Grinder Pumps designed to be rugged And economical for Residential and Pressure Sewage applications. Long discharge runs or high static heads are not a problem. The MG200 Series feature a patented cutter mechanism and recessed impeller design to effectively macerate typical domestic sewage solids into a fine slurry

Myers offers a complete turn-key system for simple selection and installation. No complicated control panel is required. For years of trouble-free service go with the leader in grinder pump technology.

Advantages By Design
Ideal For Use In Pressure Sewer Systems
  • Choice of standard, high head or high flow designs.
  • Recessed impeller provides steep non-overloading operating curve.
Durable Motor Will Deliver Many Years Of Reliable Service.
  • Oil-filled motor for maximum heat dissipation and constant bearing lubrication.
  • Recessed impeller reduces radial bearing loads, increases bearing life.
  • High torque capacitor starts single phase motor for assured starting under heavy load. No external capacitor needed.
  • Heavy duty, 2 hp listed, wide angle float switch.
  • On-winding current and temperature sensitive overload.
The MG200 Series Is Designed For Easy Maintenance.
  • Shredding ring and grinder impeller are replaceable without dismantling pump or motor.
Unit of Measure



N/A 138 ft42 m

Liquids Handling

N/A Domestic Raw Sewage

Intermittent Liquid Temperature

N/A up to 140 ºFup to 60 ºC

Winding Insulation Temperature. (Class F)

N/A 311 ºF155 ºC

Motor Electrical Data

N/A 1 ph - capacitor start/run. 2 hp 3450 rpm 230 volt; 60 Hz, 15.0 amps

Acceptable pH Range

N/A 6 to 9

Specific Gravity

N/A 0.9 to 1.1


N/A 28 to 35 SSU

Discharge, NPT

N/A 1 1/4 in31.75 mm

Minimum Sump Diameter (Simplex)

N/A 24 in61 cm

Minimum Sump Diameter (Duplex)

N/A 36 in91.4 cm


N/A 230 V


N/A 1


N/A 51.9 A11.9 kV·A


N/A 15.0 A2.9 kW3.5 kV·A


N/A 0 - 22 gpm260 lpm

NEC Code Letter


Service Factor

N/A 1.25


N/A 2 hp

Construction Material

Motor Housing Material

N/A Cast Iron, Class 30, ASTM A48

Seal Housing Material

N/A Cast Iron, Class 30, ASTM A48

Volute Case Material

N/A Cast Iron, Class 30, ASTM A48

Power Cord. 20' Material


Standard Double Tandem Mechanical Seal Material

N/A Carbon & Ceramic

Optional Double Tandem Mechanical Seal Material

N/A Tungsten Carbide

Pump, Motor Shaft Material

N/A 416 SST

Fasteners Material

N/A 300 series SST

Shredding Ring Material

N/A 440 SST, 58-60 Rockwell

Grinder Impeller Material

N/A 440 SST, 58-60 Rockwell

Recessed Impeller Material

N/A Ductile Iron (MGH) Eng. Thermoplastic (MG/MGF)

Agency Approvals

Agency Approvals